Welcome to DYN Shop

Free Shipping on order of Rs. 499 & above

Hikvision DS-3E1518P-EI/M 16-Port Gigabit Smart Managed PoE Switch with 2 Gigabit SFP Uplinks

₹12,450.00 ₹15,000.00

👁 14 people are viewing this right now

🔥 Hurry Up! Only Few left in stock!

Special deal ends in

00 Days

00 Hours

00 Minutes

00 Seconds

- +

Check Your pincode for delivery

FREE SHIPPING

Free shipping on orders above ₹499

EASY RETURNS

Hassle-Free Returns Within 7 Days

EASY EXCHANGE

Exchange online with one request

General
ShellMetal material
Net Weight2.7 kg (5.9 lb)
Gross Weight2.9 kg (6.4 lb)
Dimensions (W × H × D)440.0 mm × 44.0 mm × 220.8 mm (17.32'' × 1.73'' × 8.69'')
Operating Temperature0 °C to 45 °C (0 °F to 113 °F)
Storage Temperature-40 °C to 85 °C (-40 °F to 185 °F)
Operating Humidity5% to 95% (no condensation)
Relative Humidity5% to 95% (no condensation)
Power Supply100~240 VAC, 50/60 Hz, Max. 2.5 A
Installation ModeRack (equipped with mounting ears)
Max. Power Consumption150 W
Power Consumption in Idle20 W
Surge Protection6 kV

Network Parameters
Ports16 × Gigabit PoE port,1 × Gigabit RJ45 port,1 × Gigabit fiber optical port
MAC Address Table8 K
Switching Capacity56 Gbps
Packet Forwarding Rate41.66 Mpps
Internal Cache4.1 Mbits

Software Function
Long Range
Ports 1 to 16: up to 300 m.

Long range performance may vary depend on camera model or cable condition.
Port Isolation
Ports 1 to 18: port isolation mode to improve network security

Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
PoE WatchdogPorts 1 to 16: auto detect and restart the cameras that do not respond.
Link Aggregation
Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection.

Support static link aggregation.

Support 8 aggregation groups.
QoS
QoS is used to allocate bandwidth to different services so as to provide end-to-end service quality assurance.

Support port-based priority configuration.

Support SP and WRR priority scheduling modes.

Support DSCP-based QoS policy.
Loop Prevention
Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.

Support 802.1D STP.

Support 802.1w RSTP.
VLAN
VLAN is used for network scale planning and network health improvement.

Support 802.1Q.

Configurable VLAN ID from 1-4094.

Support Trunk, Access port mode.

Support Max. 32 VLAN.
HPP
Support one-click activation and remote management via Hik-Partner Pro. Functions supported:

1. Display the port rate.

2. Display the port bandwidth utilization rate.

3. Display the PoE power usage.

4. Display topology information.

5. Display the alarm status.

6. Restart ports and devices.

7. Enable port long-rage mode.

8. Remotely upgrade the device.
System Maintenance
Support device management via web.

Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.

Support Super IP, which is a configurable IP address (default: 10.180.190.200) for direct access.

Support management via Hik-Central Pro.

Support remote management via Hik-Partner Pro.

Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected.

Support 802.1ab LLDP for peer device discovery.

Support port mirroring for fault locating.
DHCP SnoopingDHCP Snooping can prevent unauthorized connections to DHCP servers from disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass through. Disabled by default.

PoE Power Supply
PoE StandardIEEE 802.3af,IEEE 802.3at
PoE Power Pin8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-)
PoE PortPoE: Ports 1 to 16
Max. Port Power30 W
PoE Power Budget130 W

Approval
EMCCE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020)
SafetyCB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition), CE-LVD (EN 62368-1: 2014+A11: 2017)
Chemistry
CE-RoHS (201165EU);

WEEE (201219EU);

Reach (Regulation (EC) No.19072006)

Please shoot an unboxing video when you receive the parcel and inform us immediately if any product is missing or damaged. Our policy lasts 3 days starting from the day of your delivery. If 3 days have gone by since your delivery, unfortunately, we can’t offer you a refund or exchange. Items that have been mistakenly ordered by the customer are not refundable and cannot be returned in any case. Also, the order cannot be canceled after the dispatch has been done. The customer can only replace the products if any damaged or the defected item is received. To be eligible for a replacement, your item must be unused and in the same condition that you received it. It must also be in the original packaging.